JLG TF6-42 Service Manual - Manuale (Pagina 862)

T12000 ID 04/99 10-81
Reassembly transmission
Figure 416
Position spacer to converter housing gasket on
spacer. A light coat of grease will hold gasket in
place.
Figure 417
The use of aligning studs will facilitate converter housing to
spacer installation. The transmission could be laid down to align the end
of the clutch shafts into sealing ring sleeves in converter housing. Do
not force this operation. Converter housing must be tight against
transmission spacer.
NOTE: Do not use bolts to pull converter housing in place.
Figure 418
Install converter housing to transmission case screws
and lockwashers.
See assembly instructions for proper screw location
and installation.
Figure 419
Tighten bolts to specified torque. See note in figure
417.
Figure 420
Install converter locating ring on turbine shaft.
Figure 421
Position converter assembly on stator support
and turbine shaft.