JLG TF6-42 Service Manual - Manuale (Pagina 592)

Place a friction unit (7) - suitable for the specific type of slipping -
and planetary gear (6) into the differential unit (9).
The composition of the unit is illustrated in the points below.
25% FRICTION UNIT COMPOSITION
Friction ring with increased shim (13), steel rings (14) and friction
rings (15) alternated, end ring (16) and distance piece (17).
CAUTION! As to rings (13) and (16), the side without notches must
face outwards.
45% FRICTION UNIT COMPOSITION
Friction ring with increased shim (13), steel rings (14) and friction
rings (15) alternated, end ring (16) and distance piece (17).
CAUTION! As to rings (13) and (16), the side without notches must
face outwards.
Position shim washer (18) and the first planet gear (12).
Hold them in position with bar T16C.
Using gudgeon T16A, position the second planet gear (12) and
relative shim washer (18).
Insert tool T14 in-between the two planet gears (12). Align the
whole unit, pushing bar T16C in as far as it will go, until gudgeon
T16A is expelled.
GB GB
GB GB
GB GB
a b
c d
f e
190
HOW TO ASSEMBLE THE LIMITED SLIP DIFFERENTIAL UNIT (25% AND 45%) - ASSEMBLAGGIO DIFFERENZIALE A SLITTAMENTO LIMITATO
(25% E 45%) - DIFFERENTIAL MIT BEGRENZTEM GLEITVERMOÈGEN (25% UND 45%) MONTIEREN - ASEMBLAJE DIFERENCIAL A
DESLIZAMIENTO LIMITADO (25% Y 45%) - MONTAJE DIFFERENTIEL A GLISSEMENT REDUIT (25% ET 45%)
F1240814
6
7
9
F1240815
18,2 ± 0,1
13
14
15
16
17
6
6
25%
F1240816
18,2 ± 0,1
13
14
15
16
6
6
45%
F1240495
12
T16C
18
F1240496
12
T16A
18
T16C
9
F1240497
T16C
T14