JLG TF6-42 Service Manual - Manuale (Pagina 846)

T12000 ID 04/99 10-65
Reassembly spacer plate
Figure 332
Position pump drive shaft through washer and into
spacer plate. Align roll pin in spacer plate.
Figure 333
Tap shaft into place.
Figure 334
Install locating ring on reverse idler shaft.
Figure 335
Support spacer plate and press reverse idler shaft
into position and tight against locating ring.
Figure 336
Turn spacer plate over and position tanged thrust
washer on shaft, being certain tang in washer is in
notch in spacer plate.
Figure 337
Position idler gear needle bearing on shaft.
Lubricate bearing.