Ab c f e – JLG TF6-42 Service Manual Manuale d'uso
Pagina 488
Position the crown (12) on the differential carrier (15) and lock it
with screws (11) applied with Loctite 242.
Torque wrench setting for screws: 128±142 Nm
NOTE. Secure the screws using the cross-tightening method.
Install the bearings (7) and (8) using tool T17.
If the bearings are replaced, insert the external thrust blocks in the
middle cover (5) and in the central body (2).
Position the differential unit (6) in the central body (2) with the help
of a bar and fit the middle cover (5).
NOTE. Thoroughly check the state of the O-ring (9) and make sure
that the cover is fitted with the oil discharge in the lower position.
Lock the middle cover (5) with screws (4).
Torque wrench setting for screw: 23.8±26.2 Nm
GB
GB
GB
GB
GB
a
b
c
f
e
86
HOW TO ASSEMBLE AND INSTALL THE DIFFERENTIAL UNIT - ASSEMBLAGGIO ED INSTALLAZIONE GRUPPO DIFFERENZIALE -
DIFFERENTIALAGGREGAT MONTIEREN UND INSTALLIEREN - MONTAJE E INSTALACION DEL GRUPO DIFERENCIAL -
ASSEMBLAGE ET INSTALLATION DU GROUPE DIFFERENTIEL
INSTALLING - INSTALLAZIONE - INSTALLIEREN - INSTALACION - INSTALLATION
F1240505
11
12
15
F1240506
8
7
T17
T17
F1240507
5
2
F1240482
1
2
5
9
F1240852
5
4
4
4