JLG TF6-42 Service Manual - Manuale (Pagina 854)

T12000 ID 04/99 10-73
Reassembly transmission
Figure 373
Install forward - reverse oil distributor sleeve in
transmission case with inside diameter chamfer out
(towards front of transmission) and the notch in the distributor
aligned up withthe retaining set screw hole in the transmission
case. Refer to the cleaning and inspection pages.
Figure 374
Apply Loctite #243 and install set screw in
transmission case and in oil distributor sleeve.
Figure 375
Install set screw plug.
Figure 376
Install reverse and forward clutch shaft rear bearing
in transmission case.
Figure 377
Position a new “O”-ring on lower end of the modulation
valve sleeve and spring assembly.
Install “O”-ring on other valve sleeve.
NOTE: for single modulation and hydraulic inching see
section 11.1.
Figure 378
Install valve or valves in transmission case.