JLG TF6-42 Service Manual - Manuale (Pagina 800)

T12000 ID 04/99 10-19
Reassembly 1st clutch
Figure 98
Start ring on shaft with snap ring pliers.
Figure 99
Use a sleeve with the proper inner diameter to fit over
shaft and against retainer ring. A sharp blow with a
soft hammer will compress springs and seat retainer
ring. Be sure ring is in full position in groove.
Figure 100
Install first steel outer clutch disc.
Figure 101
Install first friction (inner) clutch disc.
Alternate steel and friction until ten (10) steel and ten
(10) friction discs are in position.
Figure 102
Install clutch disc end plate.
Figure 103
Install end plate retainer ring.