JLG TF6-42 Service Manual Manuale d'uso
Pagina 422
Slightly lubricate the braking disks (7) and fit them in the arm
following the correct sequence; orient them so that the oil
circulation holes and the marks "B" are perfectly lined up.
NOTE. When installing the steel discs, the slot corresponding to
the oil level cap should always be kept free.
Check that the positioning of the sealing ring (16) on the arm is
intact; install the complete arm. Lock it into position using two
facing screws (4) and washers (5).
Check the flatness of the arms using tool T2 and finally lock the
arms with the screws (4) and the washer (5) using the cross-
tightening method.
Torque wrench setting: 298 Nm
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
20
HOW TO ASSEMBLE THE BRAKING UNITS - ASSEMBLAGGIO DEI GRUPPI DI FRENATURA - BREMSAGGREGATE MONTIEREN -
MONTAJE DE LOS GRUPOS DE FRENADO - ASSEMBLAGE DES GROUPES DE FREINAGE
F1240398
7
B
F1240387
16
F1240400
T2