JLG TF6-42 Service Manual - Manuale (Pagina 665)

T12000 ID 04/99 5-1
5. INSTALLATION DETAILS
5.1 CONVERTER DRIVE COUPLING
Measure the “A” dimension (bolt circle diameter) and order drive plate kit listed below. Note three (3) kits
have two (2) intermediate drive plates and one (1) drive plate and weld nut assembly. Three (3) kits with
three intermediate drive plates.
(1) DRIVE PLATE AND
WELD NUT ASSEMBLY
(2) INTERMEDIATE DRIVE PLATES
BOLT CIRCLE DIA.
A
BOLT CIRCLE DIA.
A
BACKING RING
BACKING RING
ALIGNMENT HOLES
(3) INTERMEDIATE DRIVE PLATES
“A” Dimension (Bolt circle diameter)
• 11.380” (288.900 mm) diameter
Kit No. 802501.
• 13.125” (333.38 mm) diameter
Kit No. 802424.
• 13.500” (342.90 mm) diameter
Kit No. 802425.
Each kit will include the following parts:
• 2 Intermediate drive plates.
• 1 Drive plate and weld nut assembly.
• 1 Backing ring.
• 6 Mounting screws.
• 6 Lockwashers.
• 1 Instruction sheet.
“A” Dimension (Bolt circle diameter)
• 11.380” (288.900 mm) diameter
Kit No. 802543.
• 13.125” (333.38 mm) diameter
Kit No. 802426.
• 13.500” (342.90 mm) diameter
Kit No. 802427.
Each kit will include the following parts:
• 3 Intermediate drive plates.
• 1 Backing ring.
• 6 Mounting screws.
• 6 Lockwashers.
• 1 Instruction sheet.
Note
T O FACILITATE ASSEMBLY , ALIGN SMALL HOLES IN DRIVE PLATES - SEE ILLUSTRATION ABOVE - ALIGNMENT HOLES .
Position drive plate and weld nut assembly on torque converter assembly with weld nuts toward converter.
Align intermediate drive plates and backing plate with holes in torque converter assembly.
Note
T WO DIMPLES 180
°
APART IN BACKING RING MUST BE OUT TOWARD ENGINE FLYWHEEL
( HOLLOW SIDE FACING TORQUE CONVERTER ASSEMBLY ). I NSTALL CAP SCREWS AND LOCKWASHERS .
T IGHTEN CAP SCREWS TORQUE 35 - 39 N. M . (26 - 29 LB . FT .).