JLG TF6-42 Service Manual Manuale d'uso
Pagina 500
Using a surface plate, reset a centesimal comparator "DG" and
place it on the measurement ring T24 (with a thickness of 30.2
mm).
Preset the comparator to approx. 2 mm.
Bring the internal bearing (9), complete with its thrust block, under
the comparator "DG".
Determine overall thickness "D" of the bearing checking the
discrepancy between this size and the size of the measurement
ring.
CAUTION! Press the thrust block in the centre and take several
measurements while rotating the thrust block.
Partially insert the thrust block of the external bearing (13).
Install tension rod T25C, measurement ring T24 and front guide
tool T25A on the thrust block of the external bearing (13).
Connect the tension rod to the press and move the thrust block of
the external bearing (13) into its seat.
Disconnect the press and remove the tension rod.
NOTE. Before starting the next stage, make sure that the thrust
block has been completely inserted into its seat.
Insert tool T26B complete with external bearing (13), measurement
ring T24 and gauged ring nut T26C.
Manually tighten.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
98
HOW TO INSTALL AND ADJUST THE BEVEL PINION - INSTALLAZIONE E REGISTRAZIONE PIGNONE CONICO - KEGELRAD INSTALLIEREN
UND EINSTELLEN - INSTALACION Y AJUSTE DEL PINÄON CONICO - INSTALLATION ET REGLAGE DU PIGNON CONIQUE
F1240523
T24
DG
F1240524
DG
9
F1240525
13
T25A
T25C
F1240526
T25B
T24
13
T25C
T25A
F1240527
F1240528
T26B
T26C
T24
13