JLG TF6-42 Service Manual Manuale d'uso
Pagina 504
Insert shim "S" (14) and the thrust block of the internal bearing (9)
in the central body.
NOTE. To hold shim "S" (14) in position, apply grease.
Position tool T25A and tension rod T25C.
Connect the tension rod to the press, fasten the thrust block and
then remove the tools.
NOTE. Before going on to the next stage, make sure that the thrust
block has been completely inserted.
Position tools T26C and T26B complete with tapered bearings (9)
and (13); manually tighten until a rolling torque has been obtained.
Insert the stem of a depth comparator "DDG" in either side hole of
tool T26C; reset the comparator with a presetting of approx. 3 mm.
Remove the comparator and release tools and bearings from the
central body.
Re-install all and insert the distance piece (10) between bearings
(9) and (13); manually tighten the whole pack.
Insert depth comparator "DDG" into tool T26B-T26C and measure
variation "H" in relation to the zero setting performed back at point
d.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
102
HOW TO INSTALL AND ADJUST THE BEVEL PINION - INSTALLAZIONE E REGISTRAZIONE PIGNONE CONICO - KEGELRAD INSTALLIEREN
UND EINSTELLEN - INSTALACION Y AJUSTE DEL PINÄON CONICO - INSTALLATION ET REGLAGE DU PIGNON CONIQUE
F1240533
14
9
F1240534
T25C
T25A
F1240535
T26C
T26B
13
9
F1240536
DDG
F1240574
9
10
13
T26C
T26B
F1240537
DDG
T26C
T26B
9
13
H