JLG TF6-42 Service Manual - Manuale (Pagina 828)

T12000 ID 04/99 10-47
Reassembly forward clutch
Figure 245
Use a sleeve with the proper inner diameter to fit over
shaft and against retainer ring. A sharp blow with a
soft hammer will compress springs and seat retainer
ring. Be sure ring is in full position in groove.
Figure 246
Install first steel (outer) clutch disc.
Figure 247
Install first friction (inner) clutch disc. Alternate steel
and friction until six (6) steel and six (6) friction discs
are in position.
Figure 248
Install clutch disc end plate.
Figure 249
Install end plate retainer ring.
Figure 250
NOTE: forward clutch pack must be checked for clutch disc
clearance. Stand the clutch assembly on end. The clutch discs on
the bottom will fall to the end plate. Measure the distance between
the clutch piston and the first steel disc by inserting a feeler gauge
or taper gauge through the slots in the clutch drum.
The required clearance is .048-.108 [1.22 - 2.74]. If the clearance is
greater than .108 [2.74], add one steel disc under the end plate.
Gauge
REV
FWD