JLG TF6-42 Service Manual - Manuale (Pagina 857)

T12000 ID 04/99 10-76
Reassembly transmission
Figure 391
Apply a very light coat of Permatex #2 to the outer diameter
of the output flange oil seal, press oil seal in oil seal sleeve. Oil seal
must be flush with one side of face of oil seal sleeve and lip of seal
must be in. Position oil seal sleeve in transmission case with
recessed portion of oil seal towards output bearing. This leaves
space between oil seal and output bearing.
Figure 392
Install oil seal sleeve retainer ring.
Figure 393
From front of transmission case, position output gear
with long hub of gear towards front.
Figure 394
Install rear output flange and shaft through ouput oil seal.
Align splines on shaft with splines on output gear.
Install shaft through gear. Use caution as not to damage oil
seal. Brake disc is an option and will not be on all units.
Figure 395
Install output shaft to output gear retainer ring.
Figure 396
Install front output shaft bearing locating ring.