JLG TF6-42 Service Manual - Manuale (Pagina 618)

Find the value of the distance washers (23) and (24) and insert
the thrust blocks of the conical bearing of the pinion into the
body of the reduction gear (11) (See «HOW TO INSTALL AND
ADJUSTTHE BEVEL PINION»).
Using tool T7 insert the snap ring (25) previously lubricated
with grease.
Assemble the pinion assembly as shown in the picture,
checking that distance piece (22) is correctly oriented.
NOTE. Apply grease to the outer surface of the distance piece
(22).
With tools T28C, T28D and T28B connected to a press, insert
the complete pinion assembly (20).
Apply Loctite 242 to the thread of the pinion and screw the ring
nut (19). Engage special wrench T30 on the ring nut and apply
bar-hold T29 to the pinion (20). Tighten the ring nut (19)
following the appropriate procedure (See «HOW TO INSTALL
AND ADJUSTTHE BEVEL PINION») and check that torque is
170 ± 220Ncm.
Using a press, fit the bearings (14) and the distance piece (16)
on the upper gear (12).
CAUTION! The distance piece (16) must be positioned
between the outer bearing and the gear.
Grease snap rings (15) and (6); position the snap rings in the
cover (9) using tool T32.
GB GB
GB GB
GB GB
a b
c d
f e
216
HOW TO ASSEMBLE INCORPORATED REDUCTION GEAR AND PINION - ASSEMBLAGGIO RIDUTTORE INTEGRATO (602) - INTEGRIERTER
REDUZIERER MONTIEREN (602) - ASEMBLAJE REDUCTOR INCORPORADO Y PINON - MONTAJE REDUCTEUR INTEGRE (602)
F1240649
11
T7
F1240650
22
F1240651
20
F1240652
T29
T30
F1240653
12
14
F1240654
9 9
15
6
T32
T32