JLG TF6-42 Service Manual - Manuale (Pagina 781)

T12000 ID 04/99 9-7
9. ASSEMBLY INSTRUCTIONS (CONTINUED)
11 Clearance between clutch piston and steel separator plate to be .080-.135 [2.03-3.43]. If over .135
[3.43] clearance, add one steel outer disc under end plate.
13 Tighten regulator sleeve to 45-50 lbf.ft [61-68 N.m].
14 Use solenoid bore plug in middle position for 3-speed version only.
15 Solenoid cartridge to be assembled and tightened to 16-20 lbf.ft [22-27 N.m].
16 Apply Loctite No. 243 to thread of disc mounting screws.
17 See page 4-4 for brake information.
18 Tighten modulation valve and inching valve to 60-65 lbf.ft [81-88 N.m].
19 M10 x 1.17 - 1.20. [M10 x 30].
20 M10 x 2.32 - 2.4. [M10 x 60].
21 Use 5/16-18 x 5.00 screw.
22 Use 5/16-18 x 3.500 screw.
23 Use 3/8-16 x 5.00 screw.
24 Use 5/16-18 x 3.250 screw.
25 Use 5/16-18 x 2.00 screw.
26 Use 3/8-18 x 3.250 screw.
27 Use 5/16-24 nut.
28 Use 5/16-24 nut.
29 Use 3/8-24 nut.
30 Tighten all cartridge nuts to 4-5 lbf.ft [5-7 N.m].
Assembly instructions