JLG TF6-42 Service Manual Manuale d'uso
Pagina 534
Install thrust levers (12) and (13), then install the U-joint (14). For
details, see «HOW TO INSTALL THE U-JOINT».
Apply Loctite 270 to the threaded portion of the pins (11) and fit
them onto the piston (10).
Block them: torque wrench setting 30 ± 35 Nm.
Re-install the piston (10) and the braking disks (9). For details, see
«HOW TO ASSEMBLE THE BRAKING UNITS».
Install the arms (8) into the main body; check flatness and block
arms following the appropriate procedures illustrated in section
«HOW TO ASSEMBLE THE BRAKING UNITS».
Install the bush (6) complete with O-ring (7) and block it with screws
(5). Tighten screws with a torque wrench setting of 23.8 ± 26.2 Nm.
Install in sequence the lower O-ring (4), the lever (3) and the washer
(2) with the relative O-ring (4). Block with screw (1) and tighten
using a torque wrench setting of 23.8 ± 26.2 Nm.
CAUTION! Refer and keep to the positions marked during
disassembly.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
132
HOW TO ASSEMBLE THE MECHANIC PARKING BRAKE UNIT - ASSEMBLAGGIO GRUPPO FRENO DI STAZIONAMENTO A COMANDO
MECCANICO - MECHANISQUE HANDBREMSE MONTIEREN - ASEMBLAJE GRUPO FRENO ESTACIONAMIENTO MECANICO -
ASSEMBLAGE DU FREIN DE STATIONNEMENT MECANIQUE
F1240663
14
12 13
F1240664
11
10
F1240661
10
9
F1240641
8
F1240665
5
6
F1240666
3
1
2