JLG TF6-42 Service Manual - Manuale (Pagina 211)

22
If the shift lever is in Neutral and the vehicle stands still, servomotor calibration starts. The servomotor
applies idle throttle and the following display appears for about three seconds (no driver actions are
demanded).
The servomotor automatically applies full throttle (no driver actions are necessary) and the following
display appears for about three seconds:
Then, if no errors were encountered during the process, the calibration results are memorised in Flash
memory and will become active at the next power-up of the controller. The display looks as follows:
When errors were detected during the calibration process, the calibration results are ignored and the
display looks as follows:
Pressing the ‘S’ button once again returns the display back to the start of the currently active display
mode, allowing the user to re-calibrate the current sensor or to use the ‘M’ button to proceed with the
next calibration mode.