JLG TF6-42 Service Manual - Manuale (Pagina 472)

After applying grease, install the sealing ring (6) of the shaft, the
anti-extrusion ring (7) and the scraper ring (8) inside the cylinder
(3).
CAUTION! Thoroughly check that positioning of the anti-extrusion
ring (7) is correct.
After applying grease, install the sealing ring (6) of the shaft, the
anti-extrusion ring (7) and the scraper ring (8) in the head (2).
CAUTION! Thoroughly check that positioning of the anti-extrusion
(7) ring is correct.
Fit the seal (9) onto the outside of the head (2).
CAUTION!
1 - In order to facilitate assembly, apply grease to the outer surface
of the piston.
2 - Do not roll the seal (9) up.
Prepare the piston (5) by fitting it with the guide ring (10), the
magnetic ring (11), the O-ring (12) and the seal (13).
CAUTION!
1 - In order to facilitate assembly, apply grease.
2 - If a centring sensor is not fitted, then the magnetic ring (11)
should be replaced by another guide ring (10).
Apply tool T18 to the shaft on the opposite side of the head (2) and
centre it on the cylinder (3) so that it fits into the piston (5).
NOTE. Apply a little grease to seals and cylinder.
Push the piston (5) into the cylinder for 100 mm using a plastic
hammer.
GB GB
GB GB
GB GB
a b
c d
f e
70
HOW TO ASSEMBLE THE STEERING CYLINDER - ASSEMBLAGGIO CILINDRO DI STERZATURA - LENKZYLINDER MONTIEREN - MONTAJE
CILINDRO DE DIRECCION - ASSEMBLAGE DU CYLINDRE DE BRAQUAGE
D1240031
7 8 6
D1240032
7 8 6
D1240033
9
D1240034
5
10
11
12
13
F1240359
5
3
T18
F1240360
5
3