JLG TF6-42 Service Manual Manuale d'uso
Pagina 462
Check that the O-rings (15) of the axle unit are in good condition;
lubricate the seats of the seals (15) and fit the steering cylinder (9)
into its seat.
Lock the cylinder by cross- tightening the screws (8).
Torque wrench setting: 116±128 Nm
Apply Loctite 242 to the thread and connect the steering bars by
screwing the terminals onto the piston stem.
Torque wrench setting: 240±270 Nm
NOTE. Versions with coupling require that the rim of the
articulation (13) is riveted onto the surfaces of the piston stem.
Insert the pins (4) in the steering case (7) and lock into position
using a torque wrench setting of 260±290 Nm.
Find the position of the notching in relation to the hole of the cotter
pins and tighten the nut (6) further.
CAUTION! Check that rubber guards (A) are intact.
Insert the cotter pins (3) and bend the safety stems.
CAUTION! Use new cotter pins.
Install the proximity (1) for checking piston centring - if applicable -
and tighten the screws (10).
Torque wrench setting: 5±6 Nm
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
60
HOW TO INSTALL THE STEERING CYLINDER - INSTALLAZIONE CILINDRO DI STERZATURA - LENKZYLINDER INSTALLIEREN -
INSTALACION CILINDRO DE DIRECCIOÂN - INSTALLATION DU CYLINDRE DE BRAQUAGE
F1240409
9
F1240410
9
8
F1240411
13
F1240412
7
A
F1240413
6
3
F1240401
10