JLG TF6-42 Service Manual - Manuale (Pagina 858)

T12000 ID 04/99 10-77
Reassembly transmission
Figure 397
Position front output flange and bearing assembly
on output shaft. Using snap ring pliers as shown.
Squeeze snap ring ends together and tap flange
assembly into case until snap ring can seat in snap ring
groove.
Figure 398
Install high and 3rd clutch shaft rear bearing outer
race.
Figure 399
Install high and 3rd clutch assembly.
Figure 400
Install forward and reverse clutch assembly.
Figure 401
Install 1st and 2nd clutch shaft rear bearing outer
race.
Figure 402
Install 1st and 2nd clutch assembly.