JLG TF6-42 Service Manual Manuale d'uso
Pagina 620
Re-install the differential unit (18) and the intermediate cover
(17).
CAUTION! If the crown has been replaced, reinstate clear-
ances.
For details, see «HOW TO ASSEMBLE AND ADJUST THE
DIFFERENTIAL UNIT».
Re-install the complete arm checking flatness and blocking the
arm by keeping to the appropriate procedures illustrated in
section «HOW TO ASSEMBLE THE BRAKING UNITS».
Also connect the steering bar.
Fit the lower gear (13) onto the pinion (20).
Insert the upper gear unit (12) into the body of the reduction
gear (11).
Apply Loctite 510 to the locking surface of the body of the
reduction gear (11).
Lubricate snap rings (6) and (15); fit cover (9) and set cover (if
necessary) by lightly tapping with a plastic hammer.
Block cover (9) with screws (7) and (8) and relative washers
(10). Tighten using the criss-cross method.
Torque wrench setting: 82 ± 91 Nm
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
218
HOW TO ASSEMBLE INCORPORATED REDUCTION GEAR AND PINION - ASSEMBLAGGIO RIDUTTORE INTEGRATO (602) - INTEGRIERTER
REDUZIERER MONTIEREN (602) - ASEMBLAJE REDUCTOR INCORPORADO Y PINON - MONTAJE REDUCTEUR INTEGRE (602)
F1240642
17
18
F1240641
F1240636
13
20
F1240637
11
12
F1240635
9
12
F1240655
9
8
10
7