RCF HL 35-S Flyable 15" Passive Subwoofer - Manuale (Pagina 15)

15
EN
RECOMMENDED WORKFLOW
Pending the official and definitive simulation software, RCF recommends the use of HL 6 Shape Designer together with
Ease Focus 3� Because of the need of interaction between different software, the recommended workflow assumes the
following steps for every array in the final project:
- Shape Designer: audience and array setup� Calculation in “autosplay” mode of flybar tilt, cabinet and splays�
- Focus 3: reports here the angles, tilt of flybar and presets generated by Shape Designer�
- Shape Designer: manual modify of splay angles if the simulation in Focus 3 does not give satisfactory results in order to
check the safety factor�
- Focus 3: reports here the new angles and tilt of flybar generated by Shape Designer� Repeat the procedure until good
results are achieved�
4. RIGGING THE SYSTEM