Campomatic C46VM - Manuale (Pagina 16)

The cycle proceeds automatically in the following order:
The evacuation phase is signalled by the light for the button blinking for around 3 minutes.
The soldering phase is signalled by the light for the button coming on. This phase lasts 9
seconds. A cooling phase follows which lasts around 5 seconds.
During the unloading following phase all the lights go back to the initial start-up situation. The
discharging valve is open for 20 seconds. During this time, the machine does not accept
commands.

When the vacuum-chamber is decompressed, it is possible to open the lid and extract the
sealed bag.

As in the case of the Preserving cycle, in the cooking cycle the product will appear closely
wrapped and compressed by the bag.

At the end of the cycle, an acoustic signal is emitted (short Beep), which indicates that the
machine is ready for a new cycle.
Note: By pressing the button during the air evacuation phase, the device will pass to
the soldering phase in anticipation.
Note: The cycle can be interrupted early by pressing the button. In this case, the
device will not carry out the soldering and the chamber will be decompressed.
Wait around 20 seconds and for the acoustic signal before starting-up a new cycle.
Brief Preserving Cycle for jars
Once the container inside the vacuum-chamber has been prepared as described in the
"preparation" chapter, close the lid by pressing lightly on its front and selecting the button at
the same time.
When the cycle starts, an acoustic signal is emitted (short Beep).
16