Fronius Symo x.x-3-S - Manuale (Pagina 47)

45
EN
Class 4 status
codes Some of the class 4 status codes necessitate intervention by a Fronius-trained service en-
gineer.
Code Description Behaviour Remedy
401 No communication possible with the
power stage set
The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid
*)
406 AC module temperature sensor faulty
(L1)
407 AC module temperature sensor faulty
(L2)
408 DC component measured in the grid too
high
412 Fixed voltage mode has been selected
instead of MPP voltage mode, and the
fixed voltage has been set to too low or
too high a value.
- **)
415 Safety cut-out via option card or RECER-
BO has triggered The inverter is not feeding
any energy into the grid. *)
416 No communication possible between
power stage set and control system. The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid
*)
417 Hardware ID problem
The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid
Update inverter firm-
ware; *)
419 Unique ID conflict
420 No communication possible with the Hy-
bridmanager
421 HID range error
425 No communication with the power stage
set possible
426 -
428 Possible hardware fault
431 Software problem
The inverter is not feeding
any energy into the grid.
Perform AC reset
(switch automatic circuit
breaker off and on
again); Update inverter
firmware; *)
436 Functional incompatibility (one or more
PC boards in the inverter are not com-
patible with each other, e.g. after a PC
board has been replaced)
The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid
Update inverter firm-
ware; *)
437 Power stage set problem
438 Functional incompatibility (one or more
PC boards in the inverter are not com-
patible with each other, e.g. after a PC
board has been replaced) The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid
Update inverter firm-
ware; *)
443 Intermediate circuit voltage too low or
asymmetric The inverter is not feeding
any energy into the grid.
*)
445 - Compatibility error (e.g. due to re-
placement of a PC board)
- invalid power stage set configura-
tion
The inverter is not feeding
any energy into the grid. Update inverter firm-
ware; *)