Videotec DCJ - Manuale (Pagina 215)

Page 83 MNVADCJ01_0543
6.9.3.1 OSM setup
Connect the dome directly to the keyboard and a monitor to the dome video outlet.
- : starts dome setup (corresponding to the command Preset 128 shown in the relevant dome
instruction manual).
The dome shows the menu on video; the keyboard shows the mode change on the display:
R

6*72,1+

end setup

 or
: enter submenu and confirm the values; corresponding to key Iris Open
Joystick 4 , keys 8 e 9 : shifting the cursor within the menus, values change
 and  : correspond to the keys Previous e Next
6.9.4 Autopan
 : start autopan
7555

(0÷255): autopan speed from 0 slow 255 fast (not available for Saturn model).
7#*!
: store the present position as the first limit switch
7#*"
: store the present position as the second limit switch
6.9.5 Preset, sca n, patrol and home

: start the patrol sequence
 : movement towards the Home position, corresponding to preset position 1.
555 (1÷128) store the present position as preset position number X
555

(1÷128): movement towards previously stored preset position X
6.9.5.1 Patrol setup
The patrol sequence is set up using special codes:
7!*** : erase the patrol sequence
7!555 (1÷128): insert preset position X in the patrol sequence
7"*** : show patrol sequence
7"555 (1÷128): remove preset position X from the patrol sequence
7#555
(0÷255): assign a dwell time in seconds when reaching the position
The following is an example of setup and use of the patrol sequence:
7!*** , erase the previously defined sequence
7!**! , insert preset position 1 in the sequence
7!**% , insert position 5 in the sequence
7!**& , insert position 6 in the sequence