Intel BLADE SERVER IXM5414E - Manuale (Pagina 241)

218 Intel® Blade Server Ethernet Switch Module IXM5414E: Installation and User’s Guide:A Guide for Technically
config http secureprotocol
Use this command to enable or disable SSL and set protocol levels (versions). The protocol level can
be set to TLS1, SSL3 or to both TLS1 and SSL3.
Default both
Format config ip http secure-protocol
<ssl3/tls1/both> <add/remove>
config http secureserver adminmode
Command is used to enable/disable the SSL for secure HTTP.
Default disable
Format config http secureserver
adminmode <enable\disable>
show http info
Displays the http settings for the switch.
Format show http info
Mode Privileged EXEC
Secure-Server Administrative Mode
Indicates whether the administrative mode of secure HTTP is enabled or disabled.
Secure Protocol Level
The protocol level may have the values of SSL3, TSL1 or both.
Secure Port Specifies the port configured for SSL.
HTTP Mode Indicates whether the HTTP mode is enabled or disabled.
Quality of Service (QoS) commands
This section describes the commands used to configure and manage the Quality of Service (QoS)
features of the Intel® Blade Server Ethernet Switch Module IXM5414E. These features include:
• Access Control Lists (ACLs)
• Bandwidth provisioning
Access Control List (ACL) commands
An ACL consists of a set of rules which are matched sequentially against a packet. When a packet
meets the match criteria of a rule, the specified rule action (permit/deny) is taken and the additional
rules are not checked for a match. This section describes the commands you use to specify the
interfaces to which an ACL applies, whether it applies to inbound or outbound traffic and its match
criteria.
config acl create
Use this command to create an ACL identified by the parameter <aclid>. The ACL number is an
integer from 1 to 100.
Format config acl create <aclid>