SmartSystem Arm X1 Stabilization Arm - Manuale (Pagina 15)

Introduction
Congratulations on the purchase of SmartCAM Arm X1
Before using SmartCAM Arm X1, you must have fully understood all the information about
the adjustment and the operating modes of our product.
SmartCAM Arm X1 has been specifically designed for the purpose of supporting video
accessories installed on a sled with a standard 5/8" arm mating block.
It is forbidden and punishable by law the use of the equipment for
different purposes.
SmartCAM Arm X1 is fully compatible with any professional steadycam system currently
on the market, thanks to the Standard Arm Mating Block and the 5/8" sled pin.
The arm consists of two connected elements: each one is a parallelogram. The
suspension system is lodged in the parallelograms: it consists of a removable spring
cartridge and a preload adjustment system. All articulated joints and mobile elements are
supported by waterproof and steel caged bearings.
Avoid to submit your equipment to extreme conditions.
· For safety reasons, read and follow the instructions in this manual
· Do not overload your arm over the weight categories suggested in this manual
· The stabilization system, since it's movable and articulated, may modify
environmental light with its movement. We recommend you extreme caution.
· This equipment has been specifically designed for professional video operators and it
is exclusively addressed to them.
· Do not open or dismantle, even partially, the equipment otherwise the warranty won’t
be valid.
15