Pioneer VSX-418 S - Manuale (Pagina 40)

Additional information 09
40
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the ADVANCED
SURROUND button, press and hold the
STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the
display, press the ‘ ST – ’ button.
OK? shows in the display.
4 Press SOUND RETRIEVER to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6
Ω impedance rating.
• With the receiver in standby, press
STANDBY/ON while holding down the
MIDNIGHT/LOUDNESS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω .
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.
Power cord caution
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or an electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
wrung out well, and then wipe again with a
dry cloth. Do not use furniture wax or
cleansers.
Never use thinners, benzine, insecticide sprays
or other chemicals on or near this unit, since
these will corrode the surface.
Specifications
Amplifier section
• Continuous power output (stereo)
Front . . . . . . . . . . . . . . . . . . . . . . . .100 W + 100 W
(DIN 1 kHz, THD 1.0 %, 8 Ω )
• Rated power output
(surround / 20 Hz to 20 kHz, THD 0.06 %, 8
Ω )
Front . . . . . . . . . . . . . . . . . . . . . .95 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 W
Surround. . . . . . . . . . . . . . . . . . .95 W per channel
VSX_418_MY.book 40 ページ ２００７年１２月２７日 木曜日 午後４時３３分