Pioneer VSX-418 S - Manuale (Pagina 39)

Additional information 09
39
En
English
Français
Deutsch
Nederlands
Italiano
Español
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in
Speaker setting on page 30 to YES
or PLUS .
• Switch the LFEATT (LFE Attenuate) on page 28 to LFEATT 0 or
LFEATT 10 .
The PHASE CONTROL feature
doesn’t seem to have an
audible effect.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a
PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see
Speaker Distance on page 31).
Noise during playback of a
cassette deck. • Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back. • Set the digital volume level of the player to full, or to the neutral
position.
During a playback search,
noise is output from a DTS
compatible CD player. • This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control. • Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 22).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default.
Problem Remedy
VSX_418_MY.book 39 ページ ２００７年１２月２７日 木曜日 午後４時３３分