Proel WCS1000RX - Manuale (Pagina 14)

14
In order to select the correct frequency for each channel and to avoid interferences, we suggest to use the
following procedure:
1) Set the first delegate channel in the receiver unit. Then switch on the first delegate microphone and
press the TALK button, leaving the unit active.
2) Set the second delegate channel in the receiver unit. Then switch on the second delegate
microphone and press TALK button, leaving the unit active.
3) Repeat the procedure for delegate channel three and four.
 TIP: if there are other radio-frequency transmitters in the same coverage area where the WCS1000
system is used, we suggest to turn them on when setting the RF channels using auto-scan, so the
system will choose frequencies that are truly free.
IMPORTANT NOTE: the transmitting channels are set on the receiver unit only. The WCS1000RX
manages the RF channels and tell to the chairman and delegate units which RF channel they have
to use. To do that WCS1000RX uses the room control channel and this is why it’s so important that
the room control channel is the same for all units. See above about how to set the room control
channel on WCS1000RX, further in the manual you can see how to set it on transmitter units.
WCS1000C and WCS1000D INSTALL OR REPLACE THE BATTERY PACK
When the display on WCS1000C or WCS1000D units shows a low battery level or when the battery pack is
completely exhausted, replace the battery pack as follows:
IMPORTANT: be careful to respect always the polarity marked inside the battery inlet.
Remove the batteries if you don’t use the microphone for a long period of time: this will avoid the
corrosion of the battery contacts.