Fulgor Milano FDW 8207 - Manuale (Pagina 21)

19
GB
1. Load the racks
Remove food residues and the most stubborn stains.
2. Add the detergent
The detergent compartment is divided into a smaller compartment for the pre-wash cycle and
one for the main wash cycle.
3. Check that the movement of the spray arms is not hampered.
4. Switch the dishwasher on
5. Select a wash programme and start the wash cycle
For crockery soiled due to normal use, use the Daily wash programme (see Programme
Table).
6. Close the dishwasher door
Simbologie usate nel presente manuale
Indications concerning the proper use of the dishwasher.
Point in which is expressed a note of particular importance for the prevention of injuries
or property damage.
QUICK REFERENCE GUIDE
WARNING - THIS APPLIANCE MUST BE
EARTHED
Fuse replacement
If the mains lead of this appliance is fitted with a BS
1363A 13 amp fused plug, to change a fuse in this
type of plug use an A. S. T. A. approved fuse to BS
1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B)
2. Fit replacement 13A fuse into fuse cover
3. Refit both into plug.
IMPORTANT:
The fuse cover must be refitted when changing a
fuse and if the fuse cover is lost the plug must not
be used until a correct replacement is fitted. Correct
replacements are identified by the colour insert or the
colour embossed in words on the base of the plug.
Replacement fuse covers are available from your
local electrical store.
CONNECTION TO A REWIREABLE PLUG
If the fitted plug is not suitable for your socket outlet,
then it should be cut off and disposed of in order to
avoid a possible shock hazard should it be inserted
into a 13A socket elsewhere. A suitable alternative
plug should then be fitted to the cable.
The wires in this mains lead are coloured in
accordance with the following code:
BLUE “NEUTRAL” (“N”)
BROWN “LIVE” (“L”)
GREEN AND YELLOW “EARTH” (“E”)
1. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is marked
with the letter “E” or by the Earth symbol or
coloured green or green and yellow.
2. The BLUE wire must be connected to the terminal
which is marked with the letter “N” or coloured
black.
3. The BROWN wire must be connected to the
terminal which is marked with the letter “L” or
coloured red.
Electrical Connection (UK only)
IF THE MAINS LEAD OF THE APPLIANCE IS FITTED
WITH A PLUG