Proel PLIS1200CN - Manuale (Pagina 7)

WELCOME
Thank you for choosing the Follow Spot STAPPOINT 1200CN. Prior to use, we suggest you to read carefully the instructions.
TECHNICAL SPECIFICATION
Power supply: 230 V 50 Hz or 120 V 60Hz on request
Lamp: HMI1200GS Osram
Code: PLLPHMI1200GS
Control signal: DMX 512
Number of channels: 4
Dimensions: (1055x460x320) mm
Control handle: (395x325x235) cm
Weight: 40 Kg
Iris: 10-100%
Effects: Strobe effect with adjustable speed (1-7 flashes/sec). Dimmer effect (0-100%). Blackout.
Housing Protection: IP20
FUNCTIONS
•
Safety standard compatible, IP 20 protection level.
• Quick, accurate, stable and noiseless color switching system, free of the problems in mechanical color switch.
•
Embedded with overheat protection and high voltage line protection.
•
3 Axles flow fans for cooling optimised internal air duct design, sufficient heat emission.
•
Rainbow effects.
INSTALLATION
Power up
Make sure the power supply is sufficient for the power consumption of the lamps before power up. Otherwise the power lines and the
projectors might be damaged.
Installation and removal of lamps
Make sure the power is cut and the lamps are cooled before the operation. You just unscrew the 2 copper screws which on the sides
of the lamp, and replace the lamp slightly. No other parts need to be removed. When replacing the lamp, keep the fume cock upward
and do not touch the lamp globe. The lamp shall be firmly planted to avoid bad connection and damage to the circuit.
Communication connection
The insulation resistance of all the installation equipments and the electrical lines shall be up to the safety standard and the machine
crust shall be well grounded.
ATTENTIONS FOR USE
Power On/Off
The gas discharge lamps shall not be used in an on and off manner. Each time the lamps are turned off, the lamps shall be cooled for
at least 20 minutes before the lamps are turned on again. Otherwise, high voltage discharge short circuit or interference to periphery
equipment might arise.
7