dB TECHNOLOGIES DSX 2040 - Manuale (Pagina 15)

E
n
g
lis
h
27
E
n
g
lis
h
28
NAME:
A descriptive name of up to 12 characters can be assigned to each program.
7.3 COPY CHANNELS
Copy Channels from the source to the target. When the Source and Targets are both Inputs
and Outputs, all audio parameters will be copied. When one of the Source or the Target is
an input while the other is an output, only the Level, Polarity, Delay, EQ, Crossover, and
Channel Name are copied.
SOURCE:
This is the channel to be copied from.
TARGET:
This is the channel to be copied to.
SYSTEM Store
NAM: ____________
7.4 GENERAL SETTINGS
FREQ MODE:
This changes the frequency control mode for EQ and crossover filters. It can be 36
steps/octave or All Frequencies (1 Hz resolution).
DELAY UNIT:
This sets the time unit for input and output delay to ms, ft, or m.
7.5 COMMUNICATION SETTINGS
NOTE: User must power cycle the unit for this settings to take effect.
BAUD RATE:
The sets the baud rate of the serial communication. XConsole uses a baud rate of
115200, it should be left unchanged for most user.
DEVICE ID:
This control assigns a device ID from 1 to 16 to the unit. This ID is only useful when a
network of more than 1 unit is used in conjunction with 1 or more XConsole.
NETWORK ID:
This control assigns a network ID from 0 to 60000 to the unit. This ID is used for future
network expansion only, please leave it at 0.
SYSTE M Copy
SOURCE:In1
SYSTEM Copy
TARGET:In2
SYSTEM Generl
FREQ MODE:All
SYSTEM Generl
DELAY UNIT:ms
SYSTEM Store
P:1 ____________
7.2 PRESET STORE
The DSX 2040 has a built in non-volatile memory that can store up to 30 different preset
setups. A program can be stored using this menu. The old program with the same program
number will be replaced. Once the program is stored in the flash memory, it can be recalled
at a later time, even after power down.
P:
This control selects which preset location in the non-volatile memory to be saved.
SYSTEM Comm
DEVICE ID :1
SYSTEM Comm
NETWORK ID : 0
SYSTEM Comm
BAUD