Samsung RL38HGSW - Manuale (Pagina 16)

16
‑ DISASSEMBLY OF THE
FREEZER DOOR
REVERSING THE DOOR SWING
SHAFT
GROMMET HINGE
8. With 11mm wrench,
separate the HINGE
SHAFT and then flip the
HINGE and reattach the
HINGE SHAFT.
9-1. After rejoining the COVER
WIRE HINGE L and
the ASSY HINGE UPP,
Switch the position of the
GROMMET HINGE and the
CAP SPACE DOOR.
10. Switch the position of the
STOPPER DOOR and
the GROMMET HINGE
as shown.
11. Remove 2 bolts and screw
to disassemble the ASSY
HINGE MID.
14. Disassemble the ASSY
HINGE LOW as shown
and put the AUTO GUIDE
upside down, switch the
position of the SHAFT.
12. Disassemble the Freezer
door by lifting it upward.
Be careful not to drop and
scratch the Freezer door.
13. Disassemble the COVER
LEG FRONT by removing
the 2 screws.
ASSY HINGE
LOW
AUTO GUIDE
COVER LEG
FRONT
When joining, tighten
a screw not to make
unpredicted noise.
STOPPER
GROMMET
7. Switch the direction of the
electric wire as below. Take
out the COVER WIRE HINGE
L from the underneath the
CAP CABI and rejoin it with
the electric wire.
9-2. When disassembling
CAP SPACE, do not
Push both side hooks
but bottom hook as
shown.
Note
DA99-01220G(1.1).indb 16 2010.6.21 11:40:15 AM