Onkyo DR-S501 - Manuale (Pagina 43)

43
Using the Listening Modes—Continued
T-D (Theater-Dimensional) Listening Angle
Setting
With this setting, you can specify the angle of the front
left and right speakers relative to the listening position.
Processing for the Theater-Dimensional listening mode
is based on this setting. Ideally, the front left and right
speakers should be equidistant from the listening posi-
tion and at an angle close to one of the three available
settings.
Note:
Only when the T-D listening mode is selected, this set-
ting is available.
Listening Mode and Receiver Settings
Depending on the listening mode, the setup menu settings may be enabled/disabled as shown below.
✔: available
*1 During playback a DVD-Audio or SACD, this setting is fixed at 100 Hz.
*2 During playback a DVD-Audio or SACD, this setting is fixed at Small.
1
Remote controller
HOLD
Press and hold the [SETUP] but-
ton for 3 seconds.
When selecting the input other than
DVD, just press the [SETUP] button.
“Balance” appears on the display.
20/30/40°
Front left speaker Front right speaker
2 Use the Up and Down [ ]/[ ]
buttons to select “Angle”, and
use the Left and Right [
]/ [ ]
buttons to select: “Narrow”,
“Middle”, or “Wide”.
Narrow: Select if the listening angle
is 20 degrees.
Middle: Select if the listening angle
is 30 degrees (default).
Wide: Select if the listening angle
is 40 degrees.
3 When you’ve finished, press the
[SETUP] button again.
The setup menu closes.
Listening Mode
Settings Page # Pure Audio Direct Stereo T-D
Speaker Output Balance 56   ✔ ✔
Subwoofer Level 32   ✔ ✔
Correcting Sound and Picture
Sync
56   ✔ ✔
Crossover Frequency 57   ✔ *1 ✔
Enabling/Disabling the Subwoofer 56   ✔ ✔
Front Speakers Size 56   ✔ *2 ✔