Pioneer VSX-D912 - Manuale (Pagina 43)

Setting up 07
43
En
English
Italiano
Français
Nederlands
Español
Deutsch
Chapter 7:
Setting up
Choosing your receiver setup
To ensure the best possible surround sound,
be sure to complete the following set up
operations. This is particularly important
when using DTS and Dolby surround. You
only need to make these settings once (unless
you change the placement of your current
speaker system or add new speakers, etc.).
Refer to the following pages for details on
each of the settings.
1 Press RECEIVER to turn the power
on.
The STANDBY indicator goes out.
2 Press RECEIVER.
3 Use or to choose the option you
want to adjust.
It will be easiest to adjust each of the settings
in turn, following the order below (and on the
following pages). The current setting is shown
for each option as you cycle through the
display.
Speaker setting (page 44)
Specify the number and type of speakers
you have connected.
Surround back speaker setting
(page 45)
Specify your surround back speaker/
surround back subwoofer setup.
Subwoofer setting (page 45)
Specify how the subwoofer is used.
Crossover frequency setting (page 45)
Determine which frequencies will be sent
to the subwoofer (or large speakers).
LFE attenuator setting (page 46)
Choose the attenuator level for the LFE
channel.
Front left speaker distance setting
(page 46)
Specify the distance from your listening
position to your front left speaker.
Center speaker distance setting
(page 46)
Specify the distance from your listening
position to your center speaker.
Front right speaker distance setting
(page 47)
Specify the distance from your listening
position to your front right speaker.
Surround right speaker distance
setting
(page 47)
Specify the distance from your listening
position to your surround right speaker.
RECEIVER
ENTER
RECEIVER
VSX_712_812_912.book 43 ページ ２００３年２月６日 木曜日 午前１０時５１分